<< Click to Display Table of Contents >> Navigation:  Help Topics > Relate > General Options > Floor Reference

 

The Floor Reference option controls the point at which an invert is considered to collide with the floor.

 

Setting this option to “Hole” will tell STACK-IT that the bottom of the cutout is flush with the floor. A setting of “Pipe (Int)” means the flow line of the low pipe is flush with the floor. A setting of “Pipe (Ext)” means the outside wall of the low pipe is positioned flush with the floor.

 

Setting the Floor Reference to Pipe (Int) or Pipe (Ext) will prompt STACK-IT to set the Catch Reference to Pipe as well. Otherwise it would be possible for the catch depth to be less than zero.

 

Floor Reference is a Factory Option and must be enabled for the user to be able to select it.