|
<< Click to Display Table of Contents >> User Setup OptionsHole_Location_Rounding |
  
|
|
<< Click to Display Table of Contents >> User Setup OptionsHole_Location_Rounding |
|
Use this option to select the rounding to be applied to the hole location dimensions on the printed drawings.
Setting |
Description |
OFF |
Rounding is not applied. This is the standard setting and provides the maximum number of digits. Typically used when heights are expressed in feet or meters. |
1 |
Round to nearest integer. Typically for heights of inches or millimeters. |
0.5 |
Round to nearest half. Typically for heights of inches. |
0.25 |
Round to nearest quarter. Typically for heights of inches. |
0.125 |
Round to nearest eighth. Typically for heights of inches. |
0.1 |
Round to nearest tenth. Typically for heights of inches. |